Glowshift Transmission Temperature Gauge Manuel d'utilisateur télécharger pdf

Tinted Series Transmission Temperature Gauge

For Product Numbers: GS-T12

Wire Harness Color Code

Red:

12v Ignition Source (+) (switched)

Orange:

12v Switched Headlamp Source (+) (optional)

Black:

Vehicle Ground ( - )

Green:

Connects to the White Wire on the Temperature Sensor

1. Disconnect the vehicle's negative battery cable.

Temperature Sensor Installation

2. There are two common types of transmission temperature

sensor installations:

 Transmission Test Port: Most vehicle transmissions

come equipped with a test port location. This may be

located on either the driver or passenger sides of the

transmission near the transmission oil pan. The bolt

in this port should be removed and the sensor fitted in

its place. Confirm port and thread size with your

vehicle dealer or owner’s manual. A test port

extender will be required when installing this sensor

into Dodge Ram model years 94-07.5

 Stock Sensor Location: Use a T-fitting (optional) to

T off your stock sensor location. This will allow you

to keep your stock sensor installed, while also

allowing you to install an aftermarket temperature

sensor.

Note: Some vehicles may require additional adapters to

complete the installation of this sensor.

Connecting the Power Wire Harness

3. To make the wiring of your gauges easier you can

purchase an expandable circuit. This component easily fits

into your fuse panel and provides an additional fused power

wire for accessories such as gauges. The expandable circuit is

available for purchase at www.GlowShift.com.

4. Connect the green wire from the gauge to the white wire

of the transmission temperature sensor. Then, connect the

black wire of the transmission temperature sensor to any

good (unpainted) ground connection.

5. Using automotive grade wiring (18 gauge); connect the red

wire to a positive 12 volt ignition (switched) source. It may

be connected to the fuse panel, an accessory wire, or any

positive 12 volt source that turns on and off with the ignition.

6. Using automotive grade wiring (18 gauge); connect the

black wire to any good (unpainted) ground connection. You

may also route a wire directly to the negative side of the

vehicle’s battery.

7. The Night Time Dimming feature decreases the brightness

of the gauge face by 30%. Connect the orange wire to the 12

volt positive headlamp source. This allows the mode to be

activated when the headlights come on. This step is optional

and will not affect operation of the gauge if it is omitted.

 Note: Do not connect the orange wire to a dimmer

wheel. This will cause the gauge lighting to flicker.

8. Reconnect the vehicle's negative battery cable.

1 2

For Product Numbers: GS-T12 1

Résumé du contenu

Page 1 - For Product Numbers: GS-T12

Tinted Series Transmission Temperature Gauge For Product Numbers: GS-T12 Wire Harness Color Code Red: 12v Ignition Source (+) (switched) Orange: 12

Page 2

Additional Installation Information & Material Requirements  GlowShift Gauges Approved Conductor Wires: Successfully installing GlowShift Gauge

Commentaires sur ces manuels

Pas de commentaire

Glowshift Transmission Temperature Gauge Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Accessoires pour l'eau Glowshift Transmission Temperature Gauge. GlowShift Transmission Temperature Gauge User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires pour l'eau Glowshift Transmission Temperature Gauge